- This topic has 1 reply, 2 voices, and was last updated 5 years, 2 months ago by
.
-
Posts
-
I’m starting a new model where we are using a pre engineered metal frame system. The columns/posts of these frames are continuous from foundation to roof so some of these columns will be exterior and interior as this is on a down slope lot and the back of the house is approx 20′ in the air with the continuous columns supporting. Would I split these columns in a stack based on level and exterior/interior condition?
Hello Ruben,
You are correct. If your column features will be both exterior and interior you would group and assign them according to LEVEL>ELEMENT>LOCATION>CONDITION.
For continuous columns, you can slice them at the same height as where the levels split and then group/paste them into the appropriate levels. This won’t affect the drawings, but will make for easier organization (so no geometry exceeds the height of the level layers).
Hope this is helpful, sounds like you got a good grasp of how to use the plugin. This is a tricky one!
- You must be logged in to reply to this topic.