Back Edges visible.

00_Home › 00_Pro Forum › ConDoc 5 › Back Edges visible.

Viewing 3 posts - 1 through 3 (of 3 total)
  • Author
    Posts
  • December 17, 2022 at 7:44 am #33904
    sekar
    Participant

    Hi.,

    please find the attached screenshot.

    the back edges are turned off for the particular style  (Line Drawing – 00) by default. but it is displayed in the elevation as highlighted. Any suggestion to overcome this issue.

     

    December 21, 2022 at 2:56 pm #33914
    Mike Brightman
    Keymaster

    When you are slicing through the cabinet, you are now seeing the lines beyond.  You might adjust the style to have a white section fill…  but make a copy of the style first!  I’m guessing you did this once and modified the Line Drawing – 00 style…  Remember how I switched that off during our session?  If there is a white section fill it will block those back edges.

    December 22, 2022 at 7:20 am #33917
    sekar
    Participant

    Thanks mike.

    yes we done it in the session, the post was earlier before the session.

  • Author
    Posts
Viewing 3 posts - 1 through 3 (of 3 total)
  • You must be logged in to reply to this topic.