- This topic has 0 replies, 1 voice, and was last updated 4 years, 8 months ago by
.
Viewing 1 post (of 1 total)
-
Posts
-
I would like to make a change in the floor to floor height in a model that I created with CDArchPro and so need to change the settings in the output scenes. When I go to the plan generator, it starts fresh rather than showing the settings that I originally put in. Is there a way to adjust the information other than starting all over again with new views, etc.?
Viewing 1 post (of 1 total)
- You must be logged in to reply to this topic.