Forum Replies Created
-
Posts
-
Hey there Gary,
That is a good question. I am used now to cut it all up by floor but that’s a lot of work. Is there another logic we can use here Mike?
Kind regards,
Joris
Hey there Gary,
That is a good question. I am used now to cut it all up by floor but that’s a lot of work. Is there another logic we can use here Mike?
Kind regards,
Joris
Hello there.
The current state/layer/tag is shown above. As you can see this is correct for your project.
This can also by example be: Level 01/Walls/Interior, if you used the layers correctly.The buttons on the bottom show where you can go to.
so you can click on level 2 button to show level 2, click on exterior to show only exterior…Hope this helped understand this console.
greeting from Belgium
Vanderhasselt-interieur.be
Hello there.
The current state/layer/tag is shown above. As you can see this is correct for your project.
This can also by example be: Level 01/Walls/Interior, if you used the layers correctly.The buttons on the bottom show where you can go to.
so you can click on level 2 button to show level 2, click on exterior to show only exterior…Hope this helped understand this console.
greeting from Belgium
Vanderhasselt-interieur.be