Angled exterior walls

[Keea]

I am creating a building design where some of the exterior walls come up at an angle right out of the ground.  Using Condoc, how would I get an accurate floor plan so it shows the space of the floor and not the wall at the 4′ section cut line, which would bring in the dimension of the outside wall in considerably and then be inaccurate on the plan views?  Thanks for your time,  Keea

[Mike Brightman]

Yo Keea!  How are you!?  Great question…  I don’t think there is a way to get the section cut to net the correct results.  I would just group those walls into the 3d object/2d graphic scenario.  This way you can draft exactly what you want to see.  Does that make sense?

[Author]

Posts