Clicking Draft on Condoc system panel tries to change the current layer

00_Home 00_Pro Forum ConDoc 5 Clicking Draft on Condoc system panel tries to change the current layer

Viewing 3 posts - 1 through 3 (of 3 total)
  • Author
    Posts
  • #24138
    Kerry Adams
    Participant

    Guys,

    Whenever I select Draft on the condoc system panel, a sketchup window warning comes up with the following:

    You should normally model with the ‘current-layer’ set as ‘LayerZero’!  (I had to type zero, as for some reason the digit zero types as an o).

    Do you really want to change it to ‘CONDOC_Draft 01 – Fine’?

    What is happening here?

    Kerry

    #24156
    Mike Brightman
    Keymaster

    Hello Kerry,

    This sounds like an issue caused by another plugin. Do you happen to use another layer management plugin for SketchUp? If so, you’ll want to deactivate it before using ConDoc.

    When in doubt, open up the ConDoc System Heads-Up Display; you’ll want to make sure you’re always on Layer 0 when modeling in SketchUp. You can also click on the “House” icon – this will put you back to Layer 0 (note the green check mark). This makes it easy to group and assign to our layers. Watch our tutorials if anything seems unclear.

    #24169
    Kerry Adams
    Participant

    Yes, I was using TIG-LayerWatcher.  Deactivated it.  Works now.  Thanks Luke.

    Kerry

Viewing 3 posts - 1 through 3 (of 3 total)
  • You must be logged in to reply to this topic.