Dimensions to studs

00_Home 00_Pro Forum ConDoc 5 Dimensions to studs

Viewing 2 posts - 1 through 2 (of 2 total)
  • Author
    Posts
  • #27177
    chrisdoehrmann-com
    Participant

    I dimension my plans to face of studs and to face of concrete with the studs set back a half inch from the face of the concrete so that the wall sheathing lines up with the face of the concrete foundation. How would I create a model in SU2020 that would accurately depict the elevations with exterior and interior wall finishes and create the plans that I can accurately dimension to the studs?

    #27178
    Mike Brightman
    Keymaster

    Hello Chris!  You could add a 1/2″ face to your walls in a a separate group within the same group as your wall geometry.  Assign the 3d object layer to just the 1/2″ face and it will always be turned off in plan, but will always show in elevation, section, and perspective.  Let me know if that solves it!

Viewing 2 posts - 1 through 2 (of 2 total)
  • You must be logged in to reply to this topic.