Plan Generator

00_Home › 00_Pro Forum › ConDoc 5 › Plan Generator

Viewing 3 posts - 1 through 3 (of 3 total)
  • Author
    Posts
  • August 19, 2020 at 9:30 pm #27090
    Gregory Sarver
    Participant

    Any reason why the plan generator puts the sections planes 30 feet above origin for floor plans? I double checked settings and the section heights are set at 4′ above floor levels….???

    Greg

    August 19, 2020 at 9:33 pm #27091
    Mike Brightman
    Keymaster

    Hello Gregory!  All floor height measurements start at the “model origin”, even if you have changed the “sketching context”.  In other words, if you moved the axes using the axes tool, the plan generator still uses the model origin to start floor height calculations.  Try right clicking on your axes, then choose reset.  This is the origin that ConDoc uses.  Does that clear things up?

    August 20, 2020 at 11:55 am #27092
    Gregory Sarver
    Participant

    Thanks Mike…that did it.

    I never consciously change the model origin, and I’m not sure how that would happen in the course of modeling either, LOL.

    Greg

  • Author
    Posts
Viewing 3 posts - 1 through 3 (of 3 total)
  • You must be logged in to reply to this topic.