Send to Layout Issue

00_Home 00_Pro Forum ConDoc 4 Send to Layout Issue

Viewing 3 posts - 1 through 3 (of 3 total)
  • Author
    Posts
  • #27353

    This month I spent quite some time in learning and experimenting with Condoc 4.8. I bought a new much faster machine too and I am working with Skp 2020. This week I rebuilt an old project with the MOG, a 3-level home,  as follows:
    1. I started a new plan with the MOG Architect
    2.  Run the Plan Generator
    3. Imported MOG on every Level-Layer
    4. Cut elements from the old model and pasted them in in place the newmodel.
    So I have a new, well organised model now, it represents the existing situation.
    So far so good, but I have troubles in sending the scenes of the existing situation to LO (3 per level,  9 alltogether). After opening LO  I just found 3 drawings iIn the scrapbook : the thin lines of the first level, the thick lines of the second and the thick lines of the third level. The 6 others were missing. I closed Layout (without saving) and tried again. This time I got just one drawing in the scrapbook: the thin lines of the first  Level. Restarting the machine or changing to an other project does not help.
    Has somebody an idea what might bet he cause of this?

    #27359

    Prolem solved!
    Some elements were on the wrong level, that was enough to block the system… Learned a lot by finding out 🙄 🙂

    #27360
    Mike Brightman
    Keymaster

    Glad you got it worked out!  99% of issues can be traced back to layering/tagging in SketchUp.  After that double check your active section planes.  Nice work solving this one!

Viewing 3 posts - 1 through 3 (of 3 total)
  • You must be logged in to reply to this topic.