Transitioning existing drawings and bringing in a MOG

00_Home 00_Pro Forum ConDoc 5 Transitioning existing drawings and bringing in a MOG

Viewing 4 posts - 1 through 4 (of 4 total)
  • Author
    Posts
  • #24050
    Shawna Carpenter
    Participant

    I am in the process of learning Condoc and the Model Organization Guides.  I have a couple of drawings that I had started before learning about Condoc and MOG.  What is the process of bringing in a MOG to use as I finish my 3D drawing?  Cut and paste in place all groups in correct location (Walls, Doors, Windows, etc) in the MOG?

    I’m apprehensive about moving everything as this is all new to me.

    Thanks so much!

    Shawna

    #24079
    Ruben Benitez
    Participant

    What you described is pretty much what you want to do. It’s what I did on my 1st ConDoc project. It was a good exercise to get familiar with the ConDoc construct

     

    #24085
    Mike Brightman
    Keymaster

    Hello Shawna!  I agree with Ruben, great exercise to go through to master the system.  Technically, you could just drop the MOG and start using it to organize your model moving forward.  If everything else is in the right place, it won’t hurt anything if some of the MOG containers are empty.  Let me know if that helps!

    #24124
    Shawna Carpenter
    Participant

    Thank you Mike and Reuben!

    I think I’m getting the hang of it now.  A little slow….but making great strides.

    Shawna

Viewing 4 posts - 1 through 4 (of 4 total)
  • You must be logged in to reply to this topic.