Hello Corey! I think I am remembering that it was hard to come up with a logic that works for everyone in every situation. You are right, the roof plan is using the lowest level section plane. I think the idea is that this would be the closest representation of the roof and exterior walls for a roof/site plan. I did a few quick tests and found that deactivating the section plane for the roof – dashed scene netted decent results. Or, like you mentioned, you could just create a one off custom section plane at a higher level, or activate one of the upper level section planes. Good news is ConDoc makes the broad strokes, then you can finish by filling in the blanks. Congrats on truly reaching pro level, it sounds like you have a full understanding of the system!
