- This topic has 4 replies, 2 voices, and was last updated 3 years, 5 months ago by
.
-
Posts
-
I need to change some of the sheet numbers. For instance I want to create some Electrical Sheets (E Prefix) and HVAC (M Prefix). Do I need to create new titleblock layers to make these changes. I also want to change some of the sheet numbering
A1. floor plans
A2. Elevations
A3. Sections
A4. Schedules
Is there an easy way to accomplish this?
Thanks
Hello Mike!
All of the sheet numbering in the title blocks included with ConDoc are set up using auto-text. You can find the settings under LayOut > Document Setup > Auto-Text.
The sheet numbers are on the shared layer title block. I think the best course of action for you is…
- unlock the Title Block layer
- right-click on the sheet numbers, move to the Annotations layer
- Copy and paste the sheet numbers to each page
- manually change the sheet numbers to whatever you like (E, M, A, etc)
If you are up for it, you could dig in on auto-text and probably figure out a clever way to save some clicks.
Let me know how it goes!
Mike
Thanks Mike.
Looks like I had come to the conclusion that you just outlined. I think this is a workable solution for me at this time. Thanks for the quick response.
Are they scrapbook symbols layer specific? when I drag some of them in the disappear below the SketchUp model. I have tried using the arrange command but it does bring they forward? Got me thinking their layer might need to be above the model?
In short, no. Scrapbooks come in on the active layer of the current presentation, regardless of the scrapbook layer structure. So if you are using the ConDoc title blocks, you want to set the ANNOTATIONS layer as active. If they are dropping in behind it has to be that your active layer is at the bottom of the stack. Pretty sure that new geometry and inserted scrapbooks are always “on top” of anything else on that current layer. Let me know if that helps!
- You must be logged in to reply to this topic.