Forum Replies Created
-
AuthorPosts
-
March 7, 2019 at 12:03 am #32125Karyna KyriaziParticipant
Hi, Luke! Thanks for your attention.
I am not sure about your answer, I think is beacuse my difficult about tecnical langage in english…. I saw the tutorial about model organization, I understood your proposed method and I am trying some ways with this awsome new tools! I just was trying to exchange some toughts about my project needs.
So let me do these specifical question that I didn’t understood if you answer me:
- Why should I put the elements into a group? Can’t I put then in their specific layer without grouped? Exemple: I will put all doors in the layer “element_doors” then group those who will be keep, who will change etc and put that groups into their layer.
- Let’s figure out that in my project I will keep all the doors. In my model sistem should be: architeture>door>floor>keep. My question is: have I create four groups for doors if at the end I have only one condition? I mean, is this necessarie for condoc tools work? Or this is also configurate?
March 7, 2019 at 12:03 am #22533Karyna KyriaziParticipantHi, Luke! Thanks for your attention.
I am not sure about your answer, I think is beacuse my difficult about tecnical langage in english…. I saw the tutorial about model organization, I understood your proposed method and I am trying some ways with this awsome new tools! I just was trying to exchange some toughts about my project needs.
So let me do these specifical question that I didn’t understood if you answer me:
- Why should I put the elements into a group? Can’t I put then in their specific layer without grouped? Exemple: I will put all doors in the layer “element_doors” then group those who will be keep, who will change etc and put that groups into their layer.
- Let’s figure out that in my project I will keep all the doors. In my model sistem should be: architeture>door>floor>keep. My question is: have I create four groups for doors if at the end I have only one condition? I mean, is this necessarie for condoc tools work? Or this is also configurate?
March 2, 2019 at 9:23 pm #32117Karyna KyriaziParticipantI just found my problem: usign sketchup 2019 and open layout 2018 🙄
March 2, 2019 at 9:23 pm #22400Karyna KyriaziParticipantI just found my problem: usign sketchup 2019 and open layout 2018 🙄
March 2, 2019 at 9:10 pm #32116Karyna KyriaziParticipantI am with the same problem….
March 2, 2019 at 9:10 pm #22399Karyna KyriaziParticipantI am with the same problem….
-
AuthorPosts